Logo en.decormyyhome.com

How to clean a white carpet

How to clean a white carpet
How to clean a white carpet

Video: How to REALLY clean your CARPET plus the Science of how OxiClean Removes Stains 2024, July

Video: How to REALLY clean your CARPET plus the Science of how OxiClean Removes Stains 2024, July
Anonim

Carpets of light shades are considered impractical - they often need cleaning, spots often remain on the pile, which are not visible on a dark coating. But the benefit of the white carpet for the interior is obvious - it increases the area of ​​the room, draws attention to furniture, favorably sets off the color of other components.

Image

You will need

  • - salt

  • - white soap

  • - washing powder

  • - ammonia

  • - sawdust

  • - gasoline

  • - vinegar

  • - potato peel

Instruction manual

1

Dry clean the carpet. This will cost you more than trying to remove the stains yourself, but the result will be guaranteed - industrial chemicals rely on any kind of pollution. Although sometimes a slight shade may appear over the entire surface of the carpet.

2

Gather the carpet and take it outside, laying out in the snow. Notice the broom on the surface of the carpet and trample it a little. If the carpet is very dirty, then tap on it with a special cracker, knocking out dust. Then turn the carpet over and lay it on clean snow - repeat the manipulations with sprinkling and knocking out. Carefully sweep the carpet and bring it home.

3

Fill the carpet with fine table salt. Then take a regular brush, dampen it with water and rub the carpet, rubbing the salt. Sweep away any remaining salt and, if necessary, treat the coating again as well.

4

Severe contamination can be tried to remove with soapy water. Dilute in a liter of warm water half a spoonful of washing powder or planed white soap. Put the solution on the fleecy part of the carpet, wait a bit, then wipe the cloth with wet and dry rags.

5

Dilute two tablespoons of ammonia in a liter of water and treat areas of severe pollution. Then rub this area with a damp cloth, removing dirty water. Finally, clean the carpet with a soft, dry cloth.

6

Soak the sawdust in a solution of soapy water, add a little gasoline. Throw the sawdust on the carpet, distributing the mass with a broom. After half an hour, sweep the sawdust.

7

If the stain is fresh, then remove it immediately - press a hygroscopic sponge or a piece of dry cloth to the carpet. Then treat the stain with a brush dipped in soapy water and wait for it to dry. If traces remain, then fill this place with vinegar and after a while wash again with detergent. Fresh spots are well removed if you rub them with a rag soaked in cold water - repeat several times until the stain disappears.

8

Wash the potato peel, chop it and scatter it over the carpet. Rub heavily contaminated places with a potato mass grated - leave the composition for several hours, then wash the carpet with detergent.