Any overhaul includes re-wiring. But in order not to disturb the future look of the interior, the wiring must be laid in a shtroba.
Repair of an apartment sooner or later implies the installation of a new electrical wiring or relocation of the old line. In current apartments, hidden wiring is usually used. That is, the wires are laid in the so-called strobes, after which plaster is applied over them. Because of this, the question of how and with what help to wall the wall arises quite often.
Influence of the type of wall on the gating process
If the wall is made of brick, then no difficulties will arise. Bricks are interconnected using a cement mortar. The use of a conventional chisel and hammer will help to easily make a notch in this solution, where then the cable is laid. If it is necessary to execute a vertical laying, then make a stroba with turns or break through a brick.
Concrete wall is a completely different conversation! There is already an increased strength. If you use a hammer and chisel, the process will last quite a while. Of course, you will need to use other methods. Get a special tool called a chipper. It makes it possible to produce a strobe with the set parameters in virtually any building material. However, not everyone can afford this option, because a round sum will have to be paid for the device. In this regard, the Bulgarian is considered to be quite effective, but it is recommended to use it exclusively in extreme cases when the wall has a high strength threshold. And all because the grinder creates a lot of dust, which then causes some inconvenience and difficulties.
