Logo en.decormyyhome.com

How to deploy the toilet yourself

How to deploy the toilet yourself
How to deploy the toilet yourself

Video: How To Install Toilet Jet Sprayer πŸ’¦ Easy DIY Bidet Home Installation πŸ’© Best Health Faucet In USA 2024, July

Video: How To Install Toilet Jet Sprayer πŸ’¦ Easy DIY Bidet Home Installation πŸ’© Best Health Faucet In USA 2024, July
Anonim

Rearranging the toilet in a small room in some cases allows you to win a little extra space. To perform the work, you can invite a specialist or rearrange yourself.

Image

You will need

  • - 90 degree angled bends made of PVC, diameter 110 mm - two pieces;

  • - 45 degree bend with a seal for release;

  • - a piece of fan pipe, diameter 110 mm, with a bell;

  • - corrugated eyeliner.

Instruction manual

1

Disconnect the tap and mount the toilet, move it away from the place where the work will be carried out. With a fan pipe, using a corrugation, you can connect the toilet to the sewer - in case the repair is delayed, but you don’t want to ask for a toilet in the neighbors.

2

Assemble the design of the supply elbow from the elements prepared for installation. To better adjust the dimensions, remove the sealing cuffs from rubber from the bells and corner bends. Make sure that the ends of the knee coincide exactly with the release of the plumbing fixture that was moved to a new location and with the entrance to the fan pipe. To do this, select the optimal length of the rectilinear section, pushing and pushing the connections of these elements.

3

Mark the connection points on the elbows with a marker after fitting has been completed. Then, for the final installation, a structure sized to fit will be easier to assemble. After fitting the knee in size, disassemble the rubber cuffs with silicone grease, then put them back and reassemble the outlet structure. Connect the outlet to the toilet outlet, the other, opposite end - to the pipe in the riser.

4

Adjust the outlet structure to height. From the toilet to the riser, a uniform tilt should be ensured - at least 1-2 degrees. Through the holes in the toilet pedestal, it is necessary to mark the points with a marker to fix the device in a new place.

5

Install the tank in a new place, if the design provides for such an arrangement. Check if the edge abuts against the wall. At the points marked on the floor with a marker, drill holes for the dowels and attach the toilet to the new location chosen for it.

note

In addition to the bends, stock up on a piece of the fan pipe - you may need to lengthen the transition elbow to rearrange the toilet closest to the corner of the room or to another place of your choice.

Just in case, prepare a corrugated flexible eyeliner with a good length - it may happen that the installation of the toilet is delayed for some time. Until it is installed in a new place, it will be impossible to use it. But as a temporary outlet to the sewer, a corrugation is quite suitable - connect it to the toilet, set aside.

Useful advice

The transfer of the toilet is better timed to repair the bathroom. During this process, you will need to shift the tiles on the floor, finish the wall, so it is better to prepare for this in advance.

ο»Ώ