There comes a time when the jacket needs to be washed. In this case, you need to consider - if the product is with fur trim, it is cleaned separately. There are several ways to do this.
You will need
- - shampoo;
- - salt;
- - ammonia;
- - water;
- - starch;
- - gasoline.
Instruction manual
1
First, unfasten the fur trim from the product, if possible. On many products, collars are prudently attached with zippers or rivets.
2
If the fur trim is without visible impurities, then any shampoo for hair is perfect as a detergent. Wash the product with warm running water, adding a little of this composition. After that, rinse the fur well.
3
Dry it on a horizontal surface with a towel in advance so that it absorbs excess moisture. Comb the dried product well with a comb. Move first against the direction of the pile, and then in the direction.
4
If the fur on the jacket with visible grease spots, then clean it with a special solution. For this you will need table salt (2 teaspoons), ammonia (1 teaspoon), water (1 cup). Mix these components well.
5
Apply directly to the area of contamination. After 30-40 minutes, wash the entire product with warm water, adding a little shampoo. Dry the fur also on a horizontal surface, in a well-ventilated area.
6
A mixture of gasoline and starch is no less effective with visible dirt on the fur. Mix these components until a creamy consistency is obtained. Apply the mixture directly to the desired area.
7
After the starch absorbs dirt and grease, and the gasoline evaporates, comb the rest of the product with a comb. Repeat this procedure if necessary. After removing any visible dirt, wash the product with a little shampoo. Dry the fur well and comb.
8
If you can not or do not want to wash the fur on the jacket yourself, give the product dry cleaning. There, experienced specialists, having studied the degree of contamination and material, will select the necessary composition for cleaning. Thus, in a few days you will get an excellent result.
