Sometimes situations arise when the vacuum cleaner does not cope with the task assigned to it when cleaning the house. Do not rush to immediately go to the service or call the wizard. This problem can be solved independently.
You will need
- - vacuum cleaner;
- - filters;
- - water;
- - the bin.
Instruction manual
1
How to increase the power of the vacuum cleaner for better suction of garbage and dust from the palace? Do one useful thing - look at the filter system of your vacuum cleaner. It can be clogged and therefore the vacuum cleaner loses suction power. The first filter in the filtration system is a bag, which is the main obstacle to dust entering the vacuum cleaner with air flow. Open the lid of the dust collector (it is usually on the latch), remove the bag into which the garbage is collected, pour its contents into the bin and knock out the dust collector well. After that, check it for integrity; if it is without holes, then insert it back, while the bag does not press against the hole that leads to the motor of the vacuum cleaner. Throw away the disposable paper bag and insert a new one.
2
The second filter, which serves to protect the motor from accidental dust particles, is located in front of the motor. Check it regularly, but not as often as a dust collector. To check the second cleaner, remove the bag and pull out the filter, which is located in front of the motor hole, pulling up. Cleaning this equipment will slightly increase the power of the vacuum cleaner.
3
If you do not have an expensive vacuum cleaner, then there should be a flat filter on it made of pressed microfiber material or foam rubber; if it is damaged, find a similar material and cut the same part with scissors. On more expensive units, there may be nera filters that are washed. If you have one, then take a filter and wash it under a warm stream of water, then dry it and set it back. Remember to check the filter for holes. Even more expensive filters are carbon filters. They are the most practical and reliable. They also need to be washed, dried and put in place in the vacuum cleaner.
4
The last filter in the cleaning system is located after the motor at the air outlet of the vacuum cleaner - it captures coal dust from the electric motor brushes. This final cleaning filter has the least effect on power, but still contributes to it when completely clogged with garbage. At the outlet of the air stream from the vacuum cleaner there should be a cover - remove it and beneath it find and remove the filter, they are usually made of sheet filter material marked FST 0001. If it is clogged and painted black from dust from the motor brushes, it is better to replace it. Look in the spare parts stores for the same material or select similar material, cut the new one according to the size of the old filter, and then install it under the cover. It should be noted that these filters are used not only in simple vacuum cleaners, but also in bagless vacuum cleaners and vacuum cleaners with an aquafilter.
Related article
How to choose a vacuum cleaner for a car
