A water cooler has become an indispensable thing for the office. Sometimes the unit is purchased for home use, because the quality of tap water does not meet taste preferences and sanitary standards.
Instruction manual
1
A cooler or despenser is used to cool and heat bottled water. The device is very convenient to use. There is no need to bring a kettle with you to get boiling water, or to keep ice to drink cool water. The quality of the liquid will depend not only on the choice of the supplier, but also on the conditions of the cooler. Once a year it is necessary to clean it. This is a prerequisite to extend the life of the device and preserve people's health.
2
The best time to clean is when the water in the bottle runs out. First of all, you need to disconnect the device from the power supply. It is necessary to drain the water from a cold and hot tap. It is best to wait a while for the boiling water to cool, otherwise be careful not to burn yourself. The dispenser housing must be wiped with a damp cloth. Strong pollution will be removed with ordinary soapy water. Due attention should be paid to the tray under the taps. It can be washed under the tap using dishwashing liquid.
3
To remove the remaining water, you need to remove the cork. It, depending on the model, will be located on the rear panel from the bottom or side. The taps are removable, they can be rinsed without too much difficulty under water with detergent. To flush the internal parts of the cooler, you will need a special solution. In 5 liters of water, stir 100 g of citric acid. The liquid must be poured into the apparatus through the opening of the bottle receptacle. The fullness of the tanks can be checked by clicking on the faucet with cold and hot water. After that, you need to turn on the cooler in the network and wait until the water heats up. After the heating indicator goes off, the device should be turned off and left for 6 hours in this state for disinfection.
4
After the procedure, the cooler must be thoroughly rinsed from the solution. For these purposes, it is recommended to use bottled water, rather than that which flows from the tap. Pure water is poured in, like a solution, and then drained from taps and through an open valve. Rinsing is best repeated several times for your own safety. After the cleaning procedure, you will need to install the valve in place, insert new water into the bottle receptacle, connect the device to the network and wait for the water to heat or cool.
note
The next time you change the bottle, the needle of the bottle acceptor must also undergo hygiene. This place is most vulnerable, as it is in contact with the external environment.
Useful advice
Before installing a new bottle, you need to wipe it with an alcohol cloth, especially carefully, the contact points with the cooler. Water goes a long way while reaching its consumer.
